Month: May 2016

Categories
1911 45ACP 9mm extractor FTE FTF HTP light strikes Remington

Metro Arms 1911 Fixed, 1911 Trigger Pull Issue

I went to the range for a quick visit today. I brought two 1911s this time:  my RIA midsized 1911 in 9mm and the Metro Arms AC Commander 45.

The first thing I did was fire 50 rounds from the 1911 that was a solid shooter (the 9mm)…it ate all the ammo without issue, but at first I was shooting very low left with it as well.  See the picture’s captioning.

I started at the left corner, then went to the right corner, then stopped because I wasn’t hitting point of aim (the red).  When I did very slow trigger pulls when aiming at the center target, I hit point of aim.  I’m having issues with the 1911 trigger…it wasn’t the Metro Arms that was the issue.  That was at 7 yards.

I then began to focus on my trigger pull. I still had trouble trying to figure out which part of the finger to use, but I found that if I shot slowly, I was dead-on. I went through most of a box of ammo pretty much hitting point of aim. It’s an issue of me not being used to the trigger mechanics of a 1911.

I also had two light strikes, which was weird…I’ve not had such issues before.  They both fired when I reloaded them into the mags.

Ammo was Remington UMC 115-grain FMJ.

I then went to my trouble-maker 1911. I had no issues aiming after my 50-round session with the 9mm 1911, although my hands were sweaty and I ended up using gloves.

This is MUCH better than my last range visit, when I was hitting very low left and not being even close to center target.

I also shot 49 rounds of Geco 230-grain FMJ without ANY feed/extract issues. There was 50 in the box…yeah, I had one issue where the round didn’t extract (this is a first…this gun has an exclusive history of not feeding properly). But one in 50 is NOT bad, especially when I was having feed issues several times (ie, 2-3) with each magazine. I think the extractor needs to be replaced, but the tuning I did on it helped a LOT!

So, I’m glad I sorted these issues out.  I think I’ll put the 1911s away for a while, because they don’t shoot like my other guns and I don’t want my muscle memory getting mucked up.

Oh yeah, I decided to shoot some extra ammo I had sitting around (Remington HTP 147-grain JHP subsonic).  I shot 50 rounds of it through my Grand Power P11.  The P11 did NOT like that ammo at all.  There were lots of failures to return to battery, so much that I was hitting the back of the slide almost as much as I was pulling the trigger.  I thought that HTP wouldn’t be as bad as UMC…I was wrong.  I need to remind myself to not shoot Remington out of the Grand Power.  EVERY time I do, I’m disappointed.

Categories
1911 extractor fail to feed feed ramp range visit recoil spring SP2022

Bersa Thunder 380 Plus Listings; Metro Arm 1911 Woes

I’ve had several people reach out to me asking about where to find good-priced Bersa Thunder 380 Plus models.  Here are some:

All of those are listed on Gun Broker.  There were at least 7-10 of them listed, but most were over-priced.  I only listed those that were under MSRP, but I did list the Combat Plus because many people are asking where to find those models and supply is scarce.

Also, a few weeks ago, I ended up taking my Metro Arms 1911 (the American Classic Commander, specifically) and my Sig SP2022 9mm to the local range.

I also ended up putting 50 rounds of American Eagle 124-grain through my current carry gun, the Grand Power P11, just to test to see if it was still having issues returning to battery (it ate all 50 rounds without issue).  I’m currently at 582 total rounds through that gun.

7 yards out, American Eagle 124-grain, Grand Power P11

The SP2022 ate 60 rounds without issue.  That handgun is fantastic and is extremely easy to shoot accurately.  I’m at 279 rounds through the barrel with NO issue whatsoever.

7 yards, Remington UMC 147-grain flat-nosed FMJ, Sig SP2022 9mm

The Metro Arms has been problematic.  I shot 48 rounds through this gun this session and had many failures to feed.  In fact, when I go through my range log, This gun has a history of failing.  It isn’t the mags that are causing the issue (it happens with all three mags and two of them are new and from Wilson Combat).  I actually searched and found that this is more than likely an extractor issue.  I checked and found it was too loose.  I tightened it up and now need to revisit the range to test to see if that helps.  If it doesn’t, I’m going to buy a new recoil spring and extractor.  That should fix the issue.  Another thing of note is that the feed ramp has some major abrasions from the last range visit when I shot Tula through it…it did NOT like Tula and I’d made a note of it (and the feed ramp) in my range log.  I shouldn’t need to polish the ramp with so little ammo through the gun, especially since the ramp had a mirror finish when I received the gun.  The gun only has 188 rounds through the gun.

7 yards, Winchester White Box 230-gr FMJ, Metro Arms ACC45, one FTE (24 rounds total)

As well, the point of impact is not hitting where I’m aiming (I’m aiming for the red with the front sight covering the X.  One thing I neglected to check was my trigger finger placement and how I was actuating the trigger.

I may visit the range tonight just to test the 1911.

I still haven’t shot my AR-15 yet, either.  I’m saving that for Father’s Day.  🙂