Categories
1911 45ACP American Classic ammo B45R JHP Metro Arms Rock Island Armory SDS Imports

My Thoughts Regarding 1911s and Jacketed Hollow Point Ammunition

One thing I’ve never done is attempt to carry a 1911. Carrying means I’ve to test JHP before committing to carrying. Everyone knows (or should know) that most 1911s don’t always readily shoot JHP.

I currently have shot 429 rounds from my SDS Imports DB45R 1911. Most of that ammo has been FMJ. Since I’ve been curious about it’s carry capabilities, I’ve been trying to shoot JHP from it, initially with mixed results.

I initially shot Remington HTP 185-gr JHP, which generated several failures to feed (FTFs).

I also shot Federal LE 185-gr JHP as well (maybe 25 rounds), which also generated some FTFs.

I documented in a previous post that I’d shot International Cartridge Corporation’s (ICC) 45ACP 155-gr frangible hollow points. For the most part, these shot without issue. That ammo can be used as defense ammo.

This past week, I shot 20 rounds of Underwood ($$$) 45ACP +P 230-gr JHP. 8 of the 20 rounds generated FTFs. I was using Wilson Combat mags with this ammo. Since this ammo is expensive and since it generated so many FTFs, I will stop shooting that ammo through the DB45R. Once I suspect that the gun will shoot it without FTFs, I’ll test the ammo again.

I shot Inceptor ARX 118-gr defense ammo (non-JHP), using the WC mag. There were no FTFs.

I shot PMC Bronze 185-gr JHP (non-SD ammo), using the WC mag.. There were no FTFs.

I shot Hornady Critical Defense 185-gr JHP, using the WC mag.. There were no FTFs.

So, I now know that I can use the following ammo as viable ammo for self defense:

  • ICC 155-gr FHP
  • Inceptor ARX 118-gr
  • PMC Bronze 185-gr JHP
  • Hornady Critical Defense 185-gr JHP

I plan to continue to shoot the PMC Bronze JHP ammo as range ammo, to continue the break-in process of the DB45R 1911.

During this round of testing, I also shot the same ammo listed above from the Metro Arms American Classic Commander (ACC) 1911 chambered in 45ACP. Note that I didn’t shoot the Critical Defense nor the Inceptor ARX from this gun, since the projectiles will almost certainly feed without issue (I tested them by chambering a round of each make, as well).

I shot most of the ICC 155-gr FHP ammo from the ACC 1911. There were initially a few FTFs, but I believe the issue was a worn recoil spring. I replaced the recoil spring and the FTFs disappeared.

I shot Underwood (again, $$$) 185-gr +P JHP from this gun, using the WC mag. This ammo was almost TOO hot, but in the gun’s defense, it isn’t as heavy as the DB45R 1911, so there’s less weight to mitigate the recoil of this hot ammo. The ammo was so hot that I had to pause in shooting the 8-round mag, since my hand was in pain. Even so, there was only one FTF, but I’m sure this may have been because the ammo was so hot that I was beginning to limp wrist.

The Remington HTP 185-gr JHP was tested the visit prior to this visit. There were some FTFs.

I also shot some of the Federal LE 185-gr JHP…there were two FTFs with that.

The rest of the listed ammo shot without issue. I’m at 520 rounds shot through this 1911, so it may be close to being broken in, which is why there’s less issues with JHP with this gun.

I also shot my RIA Rock Ultra 9mm MS 1911. I also have a RIA Tac Ultra MS 1911 which has a 22TCM barrel and spring, as well as a 9mm barrel and spring. I installed the 9mm barrel and spring for this range visit.

Both 9mm MS 1911s ran without no feed issues whatsoever. I shot several types of SD ammo, some of it JHP and some of it frangible ammo. I did have one failure to extract (FTE) with the frangible ammo when shooting the Tac Ultra, but that’s to be expected with 100-gr ammo (this ammo make was Hevi-Shot).

I was extremely impressed with the 9mm MS 1911s. I’m thinking of just carrying the 9mms instead of the 45ACP 1911s.

I’ll continue to document the testing of shooting the defense ammo.

Categories
45ACP American Classic B45R Commander Metro Arms SDS Imports

45ACP Self Defense Ammo On The Way!

I plan on carrying one of my 45ACP 1911s, although I haven’t decided which to carry yet.

I bought another Alien Gear holster and it arrived last week. This holster fits the new 5″ 1911 that I bought, the SDS 1911 Duty. I’ve never tried to carry (inside the waistband) a full-sized 1911. I tried carrying the 1911 Duty two days last week. While it is thinner than my Canik TP9 Elite SC, and carries better, but it is LONG! It is long to the point that I can’t store anything in my left right-hand rear pocket.

The Alien Gear holster is very nice and isn’t the issue. It’s just that the 5″ 1911 is longer than that I’m used to and I don’t think I’m going to be able to get used to it’s length. I’ll keep the holster anyways, just in case I decide I ever need to carry the 5″ 1911.

I’m 90% sure I think I’m going to attempt to carry my Metro Arms 1911 Commander instead. I’ve a holster shell that will fit unrailed 1911 Commanders. It is currently mounted to another Alien Gear backer and will fit the gun, but the backer is meant for smaller handguns. I’ll use it for the Commander regardless.

Before carrying either gun, I need to test SD ammo from both 1911s.

I ordered the following ammo:

  • 3 x 50-round PMC 45B Bronze 45 ACP 185 gr JHP from White Birch Armory (the same place I bought the SDS 1911)
  • 3 x 20-round boxes of Underwood 45 ACP +P 185 Grain JHP from MidwayUSA
  • 3 x 20-round boxes of Underwood 45 ACP +P 230 Grain JHP from MidwayUSA

I should be able to find acceptable ammo from the above batch, and after testing, I’ll order more for carry purposes.

I’ll keep you all updated on if there are issues with using the JHP with either 1911.

Categories
1911 1911A1 45ACP 9mm American Classic Commander Metro Arms RIA Rock Island Armory

New YouTube Video – 1911 Range Day!

I tried a new format in this video, using my GoPro hat-clip. What I didnt’ account for was the volume isn’t crisp, as the hat-clip requires usage of the GoPro case, which is apparently covering the camera’s mic. 🙁

There were issues with the Metro Arms 1911. I’ve been suspecting as much the past 1-2 years, but my handgun experience is expanding and I’m confident to say that this handgun has issues with it’s sights. I’ll be looking into obtaining a new set of sights for this handgun (I wouldn’t mind having the sights that are on my RIA Tac Ultra installed on this handgun).

Also, I finally installed the 9mm barrel into my RIA Tac Ultra (I have always shot it with the 22TCM barrel installed). I shot 140 rounds of 9mm from the gun. The gun now has a total of 746 rounds through it. It’s my third most-fired handgun (the Grand Power P11 and Bersa Thunder Plus are 1st and 2nd).

There were some fails to feed when firing the Tac Ultra, but the feed issues only occurred with the OEM mags. I’ve Wilson Combat 9mm ETM mags, which didn’t have any feed issues. I also used the 38 Super mag that came with the Tac Ultra. I also used the 9mm mag that came with my RIA Rock Ultra. The latter two mag are the mags that had inconsistent issues. The feed issues were occurring mid-mag.

Lastly, I need to research who is the new US importer for Metro Arms. Eagle Imports was the importer, but they went out of business earlier this year.

Categories
1911 American Classic Commander Metro Arms plunger spring Rock Island Armory safety lever

My 1911s Have Loose Thumb Safeties

Today, I was handling my three 1911s and noticed that two of them had safeties that were rather loose.  What do I mean by loose?  Well, a good 1911 will have a safety that will have a positive click when being manipulated.  It will also take a conscious effort to actuate.  It should not actuate (on or off) by being bumped or pushed by an object that is not a finger.  The last time I took my Metro Arms American Classic Commander (that’s a mouthful) to the range, both my wife and I noticed that after loading a mag into the firearm and trying to shoot, the safety was unintentionally enabled.

Since it was Friday evening, I got a few old rags and broke them both down on my sofa while listening to the news.  I fixed both safeties.  Once I field stripped the 1911s, I removed the safeties.  The Metro Arms had a single-handled safety lever while the Rock Island Armory had an ambi safety.  Once those were removed, I remove the plunger springs from each and stretched them out a bit, which I thought would add more tension to the safety lever on each firearm.  I put together both and then tested the safeties.  The RIA 1911 safety stiffened up drastically.  The Metro Arms 1911 had to be taken down again and stretched out a bit more, but in the end, I got the safety on that firearm pretty stiff.

I’m happy that I was able to sort this out on my own.

Categories
1911 1911A1 American Classic beveled bushings Commander grips Metro Arms VZ Walkure

Metro Arms American Classic Commander – New Grips

Man, I had issues getting the grip screws out of the bushings.  The bushings kept coming out with the screws.  They’re supposed to stay in place.  I tried various methods of getting them out but I eventually ended up really tightening the screws and then suddenly loosening them, breaking the tight seal in the process.
Also, the new grips (VZ Walkure olive green) were not plug-n-play.  They required some slight grinding on the left side, on top.  That was due to the extended slide lock and extended safety.  You can’t tell that I grinded them.  Note that I also had to the the same to the OEM grips…I had to grind the left top side to accommodate the extended safety, as well.
These grips are not as aggressive as my VZ G10s that are on my Rock Island Armory 1911s, but I do notice a definite improvement in grip.  A range session is in order!  🙂
Here are some pictures.

Categories
American Classic Commander Metro Arms MS Ultra Rock Island Armory tactical

My 1911s – Possible Upgrades

I’d not done any comparisons between my 1911s, so I decided to look at them (against each other) last week.  

I found that my Metro Arms Commander lacks a magazine well.  I also found that both of my Rock Island Armory 1911s have plastic mainspring housings.

Magazine wells and metal mainspring housings aren’t essential but they do heighten the ownership experience.  Up until I read that tactical RIAs had plastic mainspring housings, I didn’t know and it didn’t bother me.  Having a magazine well helps in inserting magazines and I hadn’t noticed the lack of the well, since I have less than 100 rounds through my American Classic…still, I did not notice that it lacked a mag well when I last shot it.

So, I’m probably going to buy a blued mag well for the American Classic and two mainspring housings for both of my tactical RIA 1911s…just for the hell of it.

Categories
45ACP 9mm American Classic Commander P320C RIA Rock Island Armory Sig

3 New Guns On The Way!

Just a quick update:

I just ordered a Sig P320C in 9mm, a Metro Arms American Classic 1911 Commander 45ACP, and a RIA 1911A1 MS Tactical II in 9mm.  The Sig and Metro Arms were ordered through Bud’s Gunshop.  The Rock Island Armory 1911 was bought from Gallery of Guns.  They should arrive by the end of the week or early next week at the latest…we’ll see.

I also revised the list again. I’ll stick with the Sig P320C…I don’t need the P320SC since I can modify the P320C to be an SC model (the P320 is modular and can be converted to any other P320 model). That’s going to save some money and is the more logical way to go.

I’m halfway to my goal and might be able to meet my goal and also lessen the list.  I’ve nixed one gun so far and also decided against the Grand Power. I’m also thinking of nixing the FNS Compact, but I might keep it on the list since I’m more than likely not going to be able to get the Canik TP9 v2 (I’ve no idea when it’s supposed to be available).

UPDATE:  The 1911 9mm arrived.  I bought model number 51698 (listed as RIA M1911A1 MS Tactical II 9mm back in 2015 but no longer being carried as a production model). As well, the Metro Arms American Classic Commander in 45ACP arrived, along with the Sig Sauer P320 Compact 9mm.