I’ve two Canik TP9SAs. I bought a black one in Jan of 2014. Back then I was planning to move to CA. I’d decided to buy another TP9SA since no Caniks are on the CA DOJ Approved List of guns, so I bought the tan TP9SA.
I’d always wondered why there was a drastic difference between the two triggers. For reference, the below are the trigger pull stats for both handguns:
Black handgun:
2 lb 14.3 oz
2 lb 15.8
2 lb 7.3
3 lb 1.4
2 lb 8.0
Average – 2 lb 12.6 oz
Tan handgun:
3 lb 12.3 oz
3 lb 3.3
3 lb 2.1
3 lb 2.9
3 lb 4.8
Average: 3 lb 5.1 oz
Initially, I’d noticed that the trigger bar on the tan one appeared to be rubbing against the frame, so I thought that was why. Maybe two weeks ago, I decided to remove the slides of both and put them side by side so that I could compare components, knowing that the black TP9SA had the good trigger. Well, I noticed that the trigger springs appear to greatly differ between the two guns! The black handgun appears to have the lighter spring with more coils. The tan gun’s trigger spring is heavier with less coils.
When I posted pictures to Canik Fanatik’s forums, I was told that the tan gun had the standard spring and that the black one may be out of spec.
Keep in mind, both guns were bought new. The black handgun was bought locally, at a gun store. The tan gun was bought from Prepper Gunshop.
I dry fire both a lot, although I don’t shoot them much. I’ve a lot of handguns, so I tend to rotate my favorites a lot…the Caniks are good but are not my favorites, so the round counts for both are low. I’ve shot 150 rounds from the tan handgun and 100 rounds from the black gun. Still, that’s way too much wear from just dry firing. As well, I dry fire them roughly the same amount, but only the one handgun has excessive wear.
I mention the dry fire because the tan TP9SA has a lot of wear on the bar/lever that the spring is attached to. On the top of that lever is supposed to be a 90 degree edge. That edge is completely gone and almost worn level. On the black handgun, the edge is present. As well, on the striker surface that the trigger bar actuates, the surface is worn and material appears to be missing — it’s supposed to be a flat surface, but the area is beveled from excessive wear.
I’m currently OK with the way the black handgun’s trigger is. It’s light but not too light (it’s about as light as I’m willing to allow). There’s no wear. At least one person at Canik Fanatik’s forums thinks there’s something wrong with the black handgun, but I don’t think anything is wrong with it….as long as there’s no excessive wear, I’m OK with it.
So, I reached out to Canik and told them the issues. They replied back asking for a slew of information so that they could process the RMA. Once I get the RMA number from them, I’ll send it to them to check out, tune, or replace.
I’ll update the blog as I’m updated by Canik.
UPDATE – 4/22/2021: Century Arms currently has the Canik. Due to Coronavirus, it may be awhile before it’s repaired and sent back to me, but I’m patiently awaiting.