Category: Springfield

Categories
ammo battery failure Grand Power P11 Remington sight radius Springfield XD

Range Visit – XD Mod 2 & Grand Power P11

I spent an hour at the range last night and shot 130 rounds out of my XD and 60 rounds out of the Grand Power.

It felt so good to not divide my attention between more than 2 guns, although I did want to shoot one of the 1911s.

I started with the XD first and immediately put 9 of 10 rounds in a close grouping.

7 yards out, using Remington UMC 115-grain JHP

The thing about the Mod 2 is that it shoots extremely well for a subcompact 9mm, as the sight radius of such guns is very small.  This gun still has a small sight radius, but the recoil and snappiness is somewhat negated by the Grip Zone texturing of the grips.  The front fiber optic helps, especially since I’ve problems focusing on the front sight (I wear corrective lenses).

As I shot five different targets, my groupings got progressively worse.  I’m pretty sure it was due to incorrect finger placement on the trigger and not being smooth on the trigger, as I began to impact left of aim.  Still, it was fun to challenge myself.

I also fired the XD better with the shorter magazine (vs. using the longer magazine that has the mag sleeve).  Don’t ask me why that was the case.

The Grand Power was acting wonky.  It didn’t jam or fail to extract, but it may’ve been failing to feed due to a dirty feed ram, as the gun was failing to fully go into battery after expending and ejecting a round.  It was an intermittent issue, though, because it didn’t happen every magazine bu when it did, it was almost back-to-back failures to return to battery.

The weapon was clean when I brought it to the range.  The ammo I was shooting must’ve been extremely dirty to cause issues between 1 and 60 rounds…in fact, the gun was extremely dirty after that range visit…more than I expected for 60 rounds.  The gun was lubed, and I made sure the pivot point on the rotating barrel had lubrication.

I don’t think it was the mags that were the issue.  When I racked the gun slowly, I didn’t notice any binding.  The only thing I can think of is that the feed ramp got dirty quickly and was hampering the feeding of the next round, which would keep the slide from fully going forward.


Possible causes:

  • Ammo that doesn’t have enough powder.
  • Dirty ammo that gets the feed ramp really dirty.
  • Limp wristing (I highly doubt that’s what happened, but I list it anyways, just in case I AM limp wristing).
  • Feed ramp doesn’t like hollow point ammo.
  • Feed ramp needs to be broken in (I doubt this, but read that someone had an issue with a ramp being too polished).

UPDATE:  Well…look at this  –>  http://www.handgunforum.net/beretta/30881-failure-feed-px4-storm-compact-9mm.html.  This looks similar to my bullet list above…looks like I am on the right track.  How does this relate to my P11?  Well, the small Beretta PX4 Storms have rotating barrels as well.  It seems that these type guns might not like lighter ammo and might be prone to limp-wristing as well.

Of the two guns, I fired the XD better.  That wasn’t the case the last time I took the P11 to the range.  Blame the failures to go into battery.

I did not get any video footage, as my camera wasn’t charged before I left for the range.

I fired 100 rounds of Remington UMC 115-grain JHP, 20 rounds of Remington UMC 115-grain FMJ, and 10 rounds of Remington HTP 115-grain +P.

I’m looking forward to the next range visit so I can put more rounds through the XD and become more proficient with it.  I’m not quite looking forward to re-experiencing issues with the P11, though.

Categories
Buds Gun Shop Glock 19 Grand Power mag blocks magazines Mod.2 P11 Mk12 P320C Springfield XD

Almost done!

I just deviated from my wish list and ordered the following handguns from Gun Genie:

Springfield Armory XD9 SC Mod 2
Glock 19 Gen 4
Grand Power P11 Mk 12

Gun Genie ships FAST and when linked with a FFL that’s fast, it makes for a great purchasing experience (I bought the non-railed RIA 1911 via Gun Genie).

These are likely the last three guns I buy for a long while.

I’d nixed the Grand Power then reversed my decision and put it back on the list.  Why?  Because the backup for this choice was the Beretta PX4 Storm Compact, which is already sold in CA (meaning it’s on the CA DOJ list of approved guns…I want to bring off-list guns, which is OK for incoming residents).  It is also, in my opinion, a beautiful gun…I kept looking at it and lusting after it, so I decided to go for it, even if I’ve hangups about the mags.  I can wait until I get to CA to get the PX4.  Yes, I still have to figure out a way to block the GP mags from 12 rounds to 10…I can epoxy one or a few of my son’s Lego pieces onto the mag base plate or under the follower.  That should work…if not, I’ll figure something out.  UPDATE:  I asked Eagle Imports (on their Facebook page) if they sold 10 round mags for the GP P11 and they said they did…the caveat is that the mags are just as expensive as the full capacity mags.  At least they have 10-rounders, though.  So, if you have this gun and are looking for extra mags and live in a state that limits capacity, go to Eagle Imports (or Bersa) and purchase them.

I’d also nixed my original choice of the Springfield XD mod 2 from my list, in favor of a Sig P320 subcompact.  Then I changed my mind, as I can always buy convertible parts and convert my P320C to whichever model I feel I want…without having to register another gun (the fire control unit is what makes it a firearm…I only need one of those when switching from one configuration to another).  I also bought the silver/black dual tone version, to be a bit different (there’s no other dual tone guns in my possession or wish list).  UPDATE:  I ended up getting the P320C in addition to the XD.

The Glock 19 Gen 4 was something that’s not really been a serious need or want.  The reason why I wanted a Glock (any Glock would do) was because I know Gen 4s are not on the CA DOJ roster, which means I will not be able to get it after I move to CA.  If need be, I can sell this gun in CA for close to double the price, as off-roster guns are usually desirable, especially Glock Gen 4s (and Sig P320s).

I may have room for one more ($500 or less) gun.  I’m not sure what it would be…I can only think of another Sig P320 (any model would do).  I don’t want the FNS-9 that I initially had on my list.  I can still get another Canik TP9SA, in FDE, too, or I can wait until it’s almost time for me to leave and check to see if something new is being offered that isn’t for retail sale in CA.  UPDATE:  I ended up getting another Canik TP9SA in FDE, as well as a RIA Tactical 1911 (railed and shooting 2 different calibers).

I’m still waiting on Buds Gun Shop to send the Sig P320C and Metro Arms 1911 I ordered.  They say they’ll ship out guns within 5-7 business days and to wait until then before calling.  It’s been five (5) business days so far.  This bugs me, but I did get a great price on the P320C, so I’m trying to keep my mouth shut about the shipping wait.  I just don’t like $1000 in merchandise being in limbo without a status on processing/shipping.

I still have to convert every magazine I have to 10-round before I move.

The below is a mental breakdown of things to do over the next few months regarding getting the firearms ready for the move to California.  UPDATE:  This list is now unneeded…I’m no longer moving to CA, as of May 2015):

  • The P220’s mags are all at or under 10 rounds.
  • The SP2022 has mag blocks here.  I’ll need five (5) of them.
  • The Canik TP9SA has mag blocks here.  I’ll need at least two (2) of them, unless I order more magazines (which I should, in case I develop some bad mags)
  • The Metro Arms American Classic 1911 45ACP Commander’s mag should be ten (10) rounds or under (it’s not here yet so I don’t know what it’ll come with…I’m just assuming).  I should be able to order more mags in CA without issue, since mags of ten (10) rounds or less are legal.  I also ordered two Wilson Combat 8-round mags.
  • The Sig P320C (Compact version, not Carry version) 9mm has mag blocks here.  I’ll need at least 2 of them, I think (it’s not here yet, but I do believe Sig provides two of them).  I may order two more mags just to have extras (4+), which means I’ll need four (4) mag blocks.
  • The RIA 1911 Tactical MS 9mm mag I have is a 10 round mag, and the other three mags I ordered are 10 round Wilson Combat mags.
  • The Glock 19 I ordered will come with 3 x 10-round mags…I will not order more at this time, and I should be able to find 10-round mags in CA for this gun.
  • The Springfield XD mod 2 9mm I ordered will come with 2 x 10-round mags.  I’m not sure if I should order more.  Two will suffice for now.
  • The Grand Power P11 Mk12 should come with 2 x 12-round mags.  I will need to find some way to block them.  I’ve scoured the internet and could not find a vendor that had 10-round mags for this gun in stock…every single one showed them as out-of-stock.  As I said above, I may have to think outside of the box to limit these mags…that’s a big deal because I’m not really good at hacking such things, but I’ll try to use Lego pieces (my son has TONS of them), find the correct length, and epoxy them in place, either under the mag follower or at the base plate.  I’ve also asked Grand Power (and Eagle Imports, who imports them, I believe) if they have them available…I’ve seen no reply to my query.

So, that’s nine (9) guns.  In three (3) months.  With maybe one more to round it out to ten (10) guns. Yes, all are CA-legal.  Yes, I’m in compliance of CA law.  Yes, I’m on a mission.  Yes, I need a bigger safe!

UPDATE:

All three arrived today.  All three are in immaculate condition (they’re new, after all).  I was quite surprised with all three.  The P11 is smaller than I’d thought.  It feels good in the hand and the slide looks exotic.  It is fully ambidextrous.  The Glock 19 is also new (the test rounds were fired last month, in fact).  It not only comes with two extra backstraps, but beavertailed backstraps as well.  The 19’s three mags are very high quality.  The Springfield Armory is a looker.  The two-tone looks very appealing on this gun, as the metal is dark silver.  The fiber optic front sight is bright, too.  I like the mag with the sleeve, as it gives me a place to put my pinky when gripping the gun.