Categories
ammo Bul Armory defensive ammo range report range visit SAS II Ultralight

Summary of the SAS II UL’s 2nd Range Visit

I went to the range yesterday and shot approximately 160 rounds of ammo. Half of it was FMJ and the other half was straight-up SD ammo (none of the cheap stuff).

Some quick observations:

  • I cleaned the firearm for the first time today (a day after the 2nd range visit). It was filthy. I could see preservative oil in the upper reaches of the slide (looked like rust but I know it wasn’t – tell-tale sign of preservative oil). I didn’t deep-clean the gun – I only field-stripped the gun, but I did remove the firing pin and clean it (I didn’t have any pipe cleaners, so I didn’t clean inside the channel). I also cleaned the extractor claw (did not remove the extractor, though). The claw was nasty. The barrel was nasty and had some crud in the chamber that took some time cleaning.
  • I took the opportunity to also take apart the two mags that came with the gun. I cleaned and oiled them (light coat of oil).
  • I noticed that the rear sight was loose. I’ll need to remove the rear sight, clean the threads, and then use blue thread locker to secure it, but for now, I just tightened the rear sight screws – I’ve an optic on the way here, and I’ll be removing the rear sight anyways.
  • I received two more OEM mags today, as well as a flat trigger shoe. I thought I could quickly install the new trigger shoe – nope…I need a 1.3mm allen wrench to remove the trigger shoe. That’s going to be a bitch to get off, too – it will take time, IF it’s not secured with threadlocker. If it is, it’ll take even more time.
  • I also received two optic shims (I only needed one but I wanted redundancy). The HS507K will require the shim, otherwise I won’t be able to adjust it properly (this is a known issue with the 507K and the SAS II UL).
  • The gun fired OK during the range visit. I shot the following ammo: Herter’s Defense in 115-gr JHP, Sig V-Crown Elite Defense 124-gr JHP, Koenig Competition 110-gr JHP, Remington Golden Saber 124-gr BJHP and 147-gr BJHP, and Hevi Duty 100-gr frangible flat-nosed ammo. I also brought some Fiocchi 115-gr FMJ ammo.
  • I had two fails to feed (FTF) with the Sig ammo, one of the FTFs being a double-feed. This ammo shot a tad bit high.
  • I had two FTFs with the Koenig ammo – same deal, one of the FTFs being a double-feed. As well, this ammo shot 2-3″ high! To hit the bullseye, I had to aim 2+ inches low.
  • I had no failures with the rest of the ammo, although the Hevi Duty frangible ammo shot high.

Basically, it seems that any light-for-caliber ammo that is shot from this gun will land high. That was my experience with Inceptor ARX (65-gr fluted tip) too.

So, we’ve shot a total of 336 rounds of ammo from the SAS II UL, thus far.

I still need to master the trigger of this gun. It’s a bit more difficult to shoot (and be precise) than my other 1911 9mm handguns, part of the issue being recoil management. I’ll get better as I spend time with the gun.

Categories
ammo Bul Armory defensive ammo fail to feed range report range visit SAS II Ultralight

Bul Armory SAS II – First Range Visit

I want to focus on two things in this after action report: 1) ammo and reliability; 2) shooting – accuracy and recoil management

About shooting reliability —

So, I took the SAS II to the range today. I took maybe 200 rounds of various types of ammo. Much of it was JHP. Some was actual defensive ammo. Some was light for caliber. Some was heavy for caliber. Some was FMJ.

I shot Inceptor ARX (65 gr), Winchester Silvertip (115 and 147 JHP), Federal Hi-shok (115 gr JHP), and Fiocchi (115 gr FMJ).

2 of the ARX failed to feed, but I expected as much with this ammo…not the fault of the gun.

There were two failures to feed with the Federal Hi-shok (of 100). Hi-shok is considered to be personal defense ammo, but it’s bottom-feeder ammo – I wouldn’t carry it but it’s good enough for the range. And again, the SAS II ate 98 of 100 of it.

I shot a total of 175 rounds. The actual defensive JHPs fed without issue. Of note, the 147-gr ammo also fed without issue, which was great (Bul Armory recommends using no higher than 124-gr).

Excluding the ARX failures, the failure percentage of this range visit is 1.14%.

I know 175 isn’t much, but JHP ammo isn’t cheap, especially legit defensive ammo.

IMO, the gun is reilable enough. I know some folks have been complaining of FTFs, extraction issues, and even some fails to return to battery. I’m not seeing any of that, but my gunnery has improved quite a bit in the last few years. There were many times where I thought a few of my guns had issues and they all turned out to be issues with me. Folks who’ve been shooting for far longer than I have can sometimes experience limp wristing, for example. The SAS II is light – it needs a firm grip, IMO.

Speaking of limp wristing, we’ll now speak on accuracy and recoil management —

I don’t consider this gun to be generally snappy, although I was shooting some loads from it today that made it snappy as hell (defense ammo). Even so, I was able to manage recoil quite a bit, which is saying a lot, because I’m not the strongest guy in the world. I did come home with fatigued forearms and wrists, but that means I’m going things correctly (from my undstanding, if you’re going home with tired arms/hands/wrists, you’re executing properly).

I keep hearing folks say that the SAS II is snappy. Recoil impulse is a subjective thing, but for such a light gun, I’d have thought the recoil would’ve been much worse than it is. I remember first shooting my Glock 22 – that was an eye-opener, as I’ve shot 40 S&W without issue in the past, but not from a Glock. The G22 is light and the 40 S&W is not known for light recoil. I’d previously shot 40 S&W from metal-framed guns without issue. The G22 took me for a ride and I was very disappointed, because the recoil was harsh. The SAS II is on par with my Springfield Armory XD9 subcompact (which I shoot very well), as far as recoil is concerned, in my opinion, at least.

Accuracy-wise, it’s extremely easy to hit where you want, at realistic distances. This is not a long distance gun, but some folks can easily hit steel at 25 and even 50 yards. The trigger is crisp, as is the sight picture of the sights, which helps.

I also was able to fit the SAS II into my Tenicor Certum holster without issue (had to loosen the retention since the SAS II is thicker than my current carry gun). I then put it inside my waistband and was quite surprised – it carries far better than my single stacked Commander! The grip is much shorter and tucks in better.

Overall, I had a great time tonight. I need to continue to test ammo with this gun. Once I find a good reliable batch of ammo and I’ve shot the gun a while, I’ll start carrying it.

Range target photos are below:

First two mags; first mag was center-mass and second mag was the lower left group.
First five mags, 7 yards, various types of ammo.
Four mags (one per target). I didn’t write down at what distance I was shooting, but I keep thinking its 9 yards.
15 yards out; me being tired and not be able to see where to aim; 2 mags
Range Footage – not pretty but not meant to be; I film my shooting for training purposes and focus on my hands and the gun so that I know when I’m limp-wristing, when I’m slapping the trigger, when I’m letting the gun control me, or other things. Sometimes it’s worth showing though.
Categories
1911 2011 Bul Armory SAS II Ultralight

Bul Armory SAS II Ultralight 3.25″ – It’s Here!

It took some effort to get it today, but I did! It’s here – my first 2011!

I thought it would be a quick thing, as I’m usually in and out of a gun shop within 30 minutes when retreiving a firearm. Something happened, though.

I found that my driver’s license expired a month ago. They wouldn’t let me get my gun without a license renewal. I went straight to the DMV and, luckily, it wasn’t packed, nor was it slow. It took me maybe half an hour to get my new license – well, they gave me a temp until the new one arrives in the mail.

I went back to the gun shop and gave them both the expired and the temp license and was able to get the gun.

I used a new-to-me FFL. The experience wasn’t bad but was unusual. What I didn’t like was that they didn’t let me see the gun before the transfer process was completed. I definitely didn’t like that, as that gun could’ve had damage or could’ve been missing a mag. I like to get a looksee of the gun before the transfer is finalized.

Anyways, I checked out the gun in their parking lot while in my car. The very first thing I noticed (and everytime I pick it up, I notice it immediately) was that the firearm is extremely light. Another thing I noticed is that it’s very small. It’s not my smallest handgun but it’s close. It’s definitely my lightest 1911 handgun, though, and would be the lightest if it weren’t for my Glock 19 (it’s lighter by 3 oz). The SAS II grips are a tad bit slippery, IMO, but my hands are sometimes dry and ashy.

The sights are NICE. The fiber optic element is bright and the rear sight is blacked out. The rear sight notch is also small, so I have no doubt that this gun is probably accurate, too.

The gun racks well. Slide to frame fitment had a miniscule bit of play. The extractor at the back of the slide is flush. The trigger is money! I did a 3 pull average with my trigger gauge and it averaged at 2 lb 14 ounces.

It comes with two mags. I’m thinking on ordering two more. I’m also thinking on getting an optic, the Holosun 507K X2 ACSS or EPS Carry.

I did have issues field stripping it. I had issues getting the slide catch out while keeping the slide back at the takedown notch.

I will be shooting this gun a while before trying to carry it, because there are many folks that have had issues with their SAS II ULs. Either their guns won’t feed JHP properly or their guns exhibit limp-wristing-like symptoms.

If I have similar issues as to what others are having, I’ll give Bul Armory a chance to fix it, but I won’t have a problem selling the gun and using the cash to get a Staccato instead.

Categories
2011 Bul Armory SAS II Ultralight

Purchase Confirmed! I’ve Bought My First 2011!

Bul Armory 2011 – SAS II Ultralight 3.25″

I committed to purchasing the Bul Armory SAS II Ultralight. At one point during the purchase process, I cancelled the process, went to the Alpha Foxtrot page and almost started to order that gun instead.

I then went back to the Bul Armory page and committed to the purchase process.

Now, I’m trying to sort through the FFL process. It’s odd that Bul Armory wants the buyer to reach out to the FFL to obtain the FFL. In my experience (I’ve bought a shitload of guns via FFL), the seller reaches out to the FFL or the FFL reaches out seller to share FFL info. Asking the buyer to do that is fucking odd, in my opinion.

So, why did I almost change my mind about the Ultralight purchase? I saw the price of Ultralight mags. They are not cheap. The AF1911 S15 uses Shield Arms mags, which are cheap.

Why didn’t I buy the Alpha Foxtrot S15 instead? Their reliability/dependability is unknown. It’s an absolutely beautiful gun, but I need a carry gun to be reliable.

So, I now need to know if the SAS II UL will fit in my currentl Tenicor Certum 3 holster. UPDATE: I do believe my current holster will fit this gun! It should fit anything that’s under 4.25″ in barrel length.

I’ll also need 2-3 more mags. I also plan to try an optic with this gun.

Needless to say, I’m excited!